Hemington Driveway Gate

The Hemington driveway gate is a stylish hardwood gate which incorporates black finished steel finials.


The Hemington driveway gate a stylish hardwood gate which incorporates black finished steel finials. The finials run through the top bar of the Hemington for added strength. The lower part of the gate is tongue & groove match boarding. This adaptable gate can be used as a pair of attractive driveway entrance gates, or as a striking garden gate.

This quality made to measure gate is created using modern technology as well as traditional joinery skills. The Hemington driveway gate has strong construction with precision mortice & tenon joints and a planed finish.  Water run off features help extend the life of the gates. These features encourage the water to run off as well as impeding water ingress. The gates are also supplied treated with two coats of preservative. All gates must be treated with a modern UV oil prior to installation.

Made in Britain, the Hemington driveway gate is manufactured using ethically sourced joinery grade Iroko. 

  • Wood type: Iroko (click here for details),

  • Finish: Supplied untreated ready for treatment (click here for details).

  • Widths: Up to 6′ (1.83m) per gate.

  • Heights: Up to 6′ (1.83m) per gate.

  • Automation: Suitable for automation with the addition of a heavy duty rail (please consult a qualified installer).

  • Recommended fittings: 30″ 2 way adjustable hinge set + Ring latch + drop bolts (each gate if a pair).

  • Recommended posts: Click here for post sizes.

  • Stile Tops: Choice of stile tops are available (click here for details).

  • Rebate: Closing edge of gate can be rebated.




Additional information


All sizes made to order

Special Widths

Available to order

Special Heights

Available to order


Gates must be hung with the bracing raising up from the bottom of the stile


Joinery grade Iroko sourced in line with EU Timber Regulation


Made In Britain


As the width of a gate increase there will be a minimum height restriction to ensure that gate integrity is maintained. This allows the bracing to fully support the gate.


Until gates are installed they should be handled carefully. Do not drag across each other or across surfaces. Ideally should be stored flat on level bearers. Can be stored upright against a wall (must not be uneven) with both stiles evenly supported but preferably, not for too long. These gates have been produced at 16% moisture content and need to be kept dry. Avoid direct contact with sunlight until the gate has been fully treated

You may also like…


Go to Top