Jubilee Driveway Gate

Made in Britain logoAn unusual attractive driveway gate with detailed chamfering to stiles and top bar. 


The Jubilee driveway gate is an unusual attractive made to measure gate with detailed chamfering to stiles and top bar.

This quality made to measure gate is created using modern technology as well as traditional joinery skills. The gate has strong mortice & tenon construction and a planed finish. Additionally, the Jubilee has a heavy duty bottom rail as standard. Water runoff features help extend the life of the gates. These features encourage the water to run off as well as impeding water ingress. The gates are also supplied treated with two coats of preservative. All gates must be treated with a Modern UV wood oil prior to installation.

Made in Britain, the Jubilee driveway gate is manufactured using ethically sourced joinery grade Iroko. 

Download our Easy Quote Form here and take to your nearest stockist.

  • Wood Type: Iroko (click here for details)

  • Finish: Supplied untreated ready for treatment (click here for details)

  • Widths: Up to 12′ (3.66m) per gate.  Please note gates above 7′ (2.13m)  are for underground slide automation only.

  • Height: Up to 5′ (1.525m) per gate.

  • Automation: Gates up to 7′ (2.13m) are ready for above ground automation with a heavy duty rail. Please note over 7′ (2.13m) will have a flush heavy duty rail and will be for slide automation only. (Please consult a qualified installer).

  • Recommended Fittings: Top Ride Hinges + Ring Latch + Drop bolt & socket set (both gates if a pair). Hinges should be a minimum of a  third of the width of the gate. Click here for more information.

  • Recommended Posts: Click here for sizes

  • Stile Tops: A choice of stile tops not available on this design.



Additional information


All sizes made to order

Special Widths

Available to order

Special Heights

Available to maximum of 5' (1.525m)


Can be hung from either stile


Joinery grade Iroko sourced in line with EU Timber Regulation


Made In Britain

Water Run-off features

This gate encorporates features that aid the run off of water helping to protect the gate


Ideally should be stored flat on level bearers. Can be stored upright against a wall (must not be uneven) with both stiles evenly supported but preferably, not for too long., Until gates are installed they should be handled carefully. Do not drag across each other or across surfaces.

Please note

Gates cannot be left exposed to the elements until fully treated, These gates have been produced at 16% moisture content and need to be kept dry. Avoid direct contact withsunlight until the gate has been fully treated

You may also like…


Go to Top