Manor Driveway Gate

An impressive and imposing gate with tongue & groove match boarding which is ideal for security and privacy.


The Manor driveway gates are impressive and imposing with tongue & groove match boarding which is ideal for security and privacy. The gates are constructed using strong mortice & tenon joints with superior section sizes. Manor driveway gates have water runoff features and a planed smooth finish. Made in Britain using sustainable timber that is certified by PEFC.

Download our Easy Quote Form here and take to your nearest stockist.


  • Wood Type: Iroko & Softwood (click here for details)

  • Finish: Supplied untreated ready for treatment  (click here for details)

  • Widths: Up to 9′ (2.74m) per gate.

  • Heights: Up to 8′ (2.44m) per gate.

  • Automation: Suitable for automation with the addition of a heavy duty rail (please consult a qualified installer)

  • Recommended Fittings: 30″ two way adjustable hinges + Ring latch + Drop bolt & socket set (both gates if a pair). Hinges should be a minimum of a  third of the width of the gate.

  • Recommended Posts: Click here for sizes.

  • Stile Tops: Choice of stile tops are available (click here for details)

  • Rebate: Closing edge of gate can be rebated.

Manor Driveway gates are manufactured here in the UK. We use modern technology as well as traditional, time served joinery techniques. The softwood used in our joinery is slow grown. Slow grown softwood is more dense and as a result produces a better quality wood . Therefore a more durable gate. Redwood timber does have knots however, being slow grown this is a lot less than many other timbers.

Our Courtyard & Driveway gates are supplied pre treated with 2 coats of preservative. They must be treated with Modern UV wood oil prior to installation following the treatment manufacturers instructions.

Above all, Charltons gates are designed to grace any driveway and are built to last.




Additional information


All sizes made to order

Special Widths

Available to order

Special Heights

Available to order


Gates must be hung with the bracing raising up from the bottom of the stile


As the width of a gate increase there will be a minimum height restriction to ensure that gate integrity is maintained. This allows the bracing to fully support the gate.


Joinery grade PEFC certified sustainable timber


Joinery grade Iroko sourced in line with EU Timber Regulation


Made In Britain


Ideally should be stored flat on level bearers. Can be stored upright against a wall (must not be uneven) with both stiles evenly supported but preferably, not for too long., Until gates are installed they should be handled carefully. Do not drag across each other or across surfaces.

Please note

Gates cannot be left exposed to the elements until fully treated, These gates have been produced at 16% moisture content and need to be kept dry. Avoid direct contact withsunlight until the gate has been fully treated

You may also like…


Go to Top