Mendip Driveway Gate

Made in Britain logoSimilar to the Mells driveway gate with its part boarded lower section, but with a straight top rail. Greatly enhancing any driveway as well as creating a grand opening to any garden.

Details below.



The Mendip Driveway gate is similar to the Mells with its part boarded lower section, but with a straight top rail. Greatly enhancing any driveway as well as creating a grand opening to any garden. The style of this gate also offers security for small children and pets. Tongue & groove match boarding and strong mortice & tenon construction. The Mendip Driveway gate incorporates water run off features encourage the water to run off as well as impeding water ingress. Made in Britain, the gates are made use joinery grade timber.

These made to measure gates also have a smooth planed finish. Softwood are supplied with two coats of water based preservative. However, it’s important to note that all gates must be treated with a Modern UV wood oil prior to installation.

Download our Easy Quote Form here and take to your nearest stockist.

  • Wood type: Iroko and Softwood (click here for details)

  • Finish: Supplied untreated ready for treatment (click here for details). Available in a fully treated coloured oil finish. Click here for details.

  • Widths: Up to 8′ (2.44m) per gate.

  • Heights: Up to 8′ (2.44m) per gate.

  • Automation: Suitable for automation with the addition of a heavy duty rail (please consult a qualified installer).

  • Recommended fittings: 30″ two way adjustable hinges + Ring latch + Drop bolt & socket set (both gates if a pair). Hinges should be a minimum of a  third of the width of the gate. Click here for more information.

  • Recommended Posts: Click here for post sizes.

  • Stile Tops: Choice of stile tops are available.

    Weathered stile top


    Sculptured stile top


    Rounded stile top


    Pointed stile top





  • Rebate: Closing edge of gate can be rebated.

    gate rebate










Additional information


All sizes made to order

Special Widths

Available to order

Special Heights

Available to order


Gates must be hung with the bracing raising up from the bottom of the stile, This gate is not designed to be hung in field entrances


As the width of a gate increase there will be a minimum height restriction to ensure that gate integrity is maintained. This allows the bracing to fully support the gate.


Joinery grade Iroko sourced in line with EU Timber Regulation


Joinery grade PEFC certified sustainable timber


Made In Britain


Ideally should be stored flat on level bearers. Can be stored upright against a wall (must not be uneven) with both stiles evenly supported but preferably, not for too long, Until gates are installed they should be handled carefully. Do not drag across each other or across surfaces.

Please note

Gates cannot be left exposed to the elements until fully treated, These gates have been produced at 16% moisture content and need to be kept dry. Avoid direct contact withsunlight until the gate has been fully treated

You may also like…

Go to Top