Prestige Jubilee Driveway Gate

Made in Britain logoA very attractive and substantial driveway gate with elegant curved braces and vertical pales.


The Prestige Jubilee driveway gate is a very attractive and substantial made to measure driveway gate with elegant curved braces and vertical pales.

This quality made to measure gate has a range of features including a 70mm section size, detailed chamfering to stiles and top bar, heavy duty rail and stainless steel bolts. Available in Iroko or Oak hardwood for automation, the Prestige Jubilee driveway gate has a smooth planed finish.

These gates made to order gates are proudly Made in Britain.

Download a copy of our easy quote form HERE and take to your nearest stockist

  • Wood type: Iroko or Oak Hardwood.

  • Finish: Supplied untreated ready for treatment (click here for details)

  • Gate width: From 3′ (0.915) up to 12′ (3.66m) per gate.  Please note gates above 7′ (2.13m)  are for underground slide automation only.

  • Gate Height: From 4′ (1.22m) up to 5′ (1.525m)

  • Automation: Gates up to 7′ (2.13m) are ready for above ground automation with a heavy duty rail. Please note over 7′ (2.13m) will have a flush heavy duty rail and will be for slide automation only (please use a qualified installer to install your automated gates)

  • Stile Tops: A choice of stile top are not available on this design.


Additional information


Iroko Hardwood made to order


The number of curved "x'" and vertical pales will vary depending on the size of the gate


Gates must be hung with the bracing raising up from the bottom of the stile, See for more details, These are heavy gates and are not suitable for manual operation


For underground automation only


Joinery grade Iroko sourced in line with EU Timber Regulation

Water Run-off features

This gate encorporates features that aid the run off of water helping to protect the gate


Ideally should be stored flat on level bearers. Can be stored upright against a wall (must not be uneven) with both sides evenly supported but preferably, not for too long, Until gates are installed they should be handled carefully. Do not drag across each other or across surfaces.

Please note

Gates cannot be left exposed to the elements until fully treated, Iroko gates have been produced at 16% moisture content and need to be kept dry. Avoid direct contact withsunlight until the gate has been fully treated


Go to Top